Institut de Chimie Moléculaire et des Matériaux d'Orsay
 

Service commun

francois brisset
 


Ingénieur de recherche
ICMMO - Bât 410
Université Paris-Sud
15, rue Georges Clémenceau
91405 Orsay Cedex
FRANCE

Tél : 01.69.15.54.30
Fax : 01.69.15.47.47

Envoyer un mail

 

Activités

  • Responsable du Service de Microscopie Electronique de l'Institut, Site web plateforme, ...
  • Applications MEB, MET, EDS et autres accessoires
  • Applications, support et formations en EBSD
  • Formation et encadrement des utilisateurs (stagiaires et/ou permanents suivant conditions)
  • Enseignements Polytech'Paris-Sud, CNAM-CACEMI
  • Membre du bureau du GN-MEBA (Groupement National de Microscopie Electronique et de microAnalyses), membre du conseil d'EMAS (European Microbeam Analysis Society)

Publications

  • 2011 – "Green Wet-Chemical Route for the Synthesis of Silver and Palladium Dendrites", B. Keita, H. Brudna, R. Luis, R. Ngo Bidoum, L. Nadjo, I.M. Mbomekalle, S. Franger, P. Berthet, F. Brisset, F.Miserque, G.A. Ekedi, European Journal of Inorganic Chemistry, DOI: 10.1002/ejic.201001259.
  • 2011 – "Microstructural evolution in an Al-6061 alloy processed by high-pressure torsion and rapid anneling", A. Loucif, R.B. Figueiredo, T. Baudin, F. Brisset, T.G. Langdon, Materials Science Forum Vols. 667-669, p. 223-228.
  • 2010 – "Thermo and photoswitchable spin-crossover nanoparticles of an iron(II) complex trapped in transparent silica thin films", A. Tissot, J.F. Bardeau, E. Rivière, F. Brisset, M.-L. Boillot, Dalton Transactions, DOI: 10.1039/C0DT00321B.
  • 2010 – "Growth and density control of nanometric FeNi cyanide-bridged objects on functionalized Si(100) surface", S. Tricard, B. Fleury, C. Costa-Coquelard, V. Huc, C. David, F. Brisset, F. Miserque, S. Palacin, T. Mallah, Chem. Commun, 46, p. 4327-29.
  • 2010 – "Microstructural evolution in an Al-6061 alloy processed by high-pressure torsion", A. Loucif, R.B Figueiredo, T. Baudin, F. Brisset, T.G. Langdon, Materials Science & Engineering A 527, p. 4864-69. 
  • 2010 – "EBSD Study of Grain Boundary Evolution after Different Cold Rolling Reduction in Duplex Steel", F. Brisset, T. Baudin, J. Jura, Materials Science Forum Vols. 636-637, p. 504-510.
  • 2009 – "PEM water electrolysers : from electrocatalysis to stack development", P. Millet, R. Ngameni, S.A. Grigoriev, N. Mbemba, F. Brisset, A. Ranjbaria, C. Etiévant, International Journal of Hydrogen Energy, p. 1-10.
  • 2008 – "Microstructure studies of Zr65Cu17.5Al7.5Ni10 and Cu15Al10Ni10 glass forming alloys : Phase morphologies and undercooled melt solidification", T.A.M. Aboki, F. Brisset, J.P. Souron, A. Dezellus, P. Plaindoux, Intermetallics, 16, p. 615-624.
  • 2005 – "A study of recovery and primary recrystallization mechanisms in a  Zr-2Hf alloy", K.Y. Zhu, D. Chaubet, B. Bacroix, F. Brisset, Acta Materiala, Vol. 53, p. 5131-5140.
  • 2004 – "Nanostructure formation mechanism of alpha-titanium using SMAT", K.Y. Zhu, A. Vassel, F. Brisset, K. Lu, J. Lu, Acta Materialia., Vol. 52, p. 4101-4110.
  • 2003 – "Effect of oxidation on the fatigue crack growth resistance and the interfacial properties of a Ti-MMC laminate composite", F. Brisset, R. Valle, A. Vassel, P. Bowen, Met. and Mat. Trans, Vol. 34A, p. 1705-1717.
  • 1998 – "Effects of control mode in a cross-ply Ti-MMC at ambient and high temperature in air and in vacuum", F. Brisset, M. Shimojo, P.Bowen, Int. J. of Fatigue, Vol. 20, N° 5, p. 339-349.
  • 1998 – "Fatigue crack growth in a fiber-reinforced titanium MMC laminate at room and elevated temperatures", F. Brisset, P. Bowen, Materials Science and Technology, Vol. 14, p. 651-657.
  • 1996 – "Croissance des fissures de fatigue dans un composite Ti-6Al-4V/SCS-6 à plis croisés, à température ambiante et à haute température", F. Brisset, Revue Scientifique et Technique de la Défense, n°31, p 93-103.
  • 1995 – "The use of a single fibre test technique to investigate interfacial phenomena in SiC/Ti3Al-based composites". F. Brisset, A. Vassel, Microscopy of Composite Materials II, Oxford (UK), April 11-13, 1994. Journal of Microscopy Vol. 177, Pt 3, March 1995, p. 407-413.
  • 1993 – "Compatibility of SiC and Al2O3 continiuous fibres with titanium aluminide matrices", F. Brisset, A. Vassel, International Symphosium on Structural Intermetallics, Seven Springs, Pennsylvania (USA), Septembre 26-30, 1993. Publié dans Structured Intermetallics" ed. R.Darolia et al., p. 739-747
  • 1988 – "Pressure temperature phase diagram of (DMDCNQI)2Ag a comparative study with related compounds", R.T. Henriques, S. Tomic, W. Kang, D. Jerome, F. Brisset, P. Batail, Synthetic Metals, vol. 27,  p. 333-338.

  •